2009-2020 Nissan 370Z 2Dr Ams VIS Carbon Fiber Hood

2009-2020 Nissan 370Z 2Dr Ams Carbon Fiber Hood. VIS Carbon Fiber Hoods and Trunks are made from the finest carbon fiber material available. All VIS Carbon Fiber Hoods and Trunks are manufactured using a two-part construction design. The top layer utilizes a 100% ISO certified, Grade A carbon fiber material. The carbon fiber material is bonded to the hood using a high grade epoxy resin , and then finished with an ultra-clear (Poly Shield), UV-protective polyurethane coating to ensure a high gloss finish. Marrying aesthetics and functions, we pioneered the use of one-piece, smooth underside shell which complements the fine finish on top, and at the same time strengthens the product’s structural integrity. The edges of each hood or trunk are meticulously smoothed by hands to insure high-quality finish all around. The result is a carbon product that is unparalleled and excels above all else in quality, durability, and aesthetics. All VIS Carbon Fiber Hoods and Trunks come with a VIS badge of authenticity. Please be sure to look for the badge when purchasing. Due to the unknown nature of the intended uses of these products, hood pins are required. These products are intended for off-road use only, unless your local and state laws state otherwise.





Important When Receiving Freight: upon receiving the product(s) please be sure to inspect the item(s) for "freight damage". If there are signs of freight damage you must refuse the item due to damage then contact us immediately. Make sure to open and inspect all content(s) before signing [this includes removing the wrapping bubbles and plastics to physically inspect the item(s)]. This process usually takes about 5-10 minutes. It is the customer's responsibility to inspect the item thoroughly. If a customer fails to fully open up the box(es) and inspect their merchandise for damage, and signs the freight carrier's paperwork indicating that all merchandise was inspected (which is what is stated on all freight carriers paperwork), inspects their merchandise after the freight carrier leaves and then finds damage, or what is called "concealed damage", neither the freight carrier, nor BMC Extreme Customs will be responsible to replace or pay for repairs to the product.

CargoEdge Insurance Coverage
Due to the size of the hood, they are vulnerable to getting damaged. It’s a common mistake to confuse freight insurance with the liability insurance provided by carriers and freight forwarders. They are not the same at all. Typical carrier or forwarder liability is limited, in some cases to no more than $5.00 per lb of stolen, lost, or damaged cargo, and coverage contains many exclusions. For a typical hood which weighs less than 50lbs, that's only $250 plus freight. CargoEdge Insurance is powered and backed by UPS Capital and adds a piece of mind should your order arrive damaged or stolen.

*DISCLAIMER: All aftermarket hoods sold are either for show or off-road use only. Professional installation & Hood pins are required! The buyer assumes the entire risk as to the quality of the aftermarket parts. In the event such parts prove defective following the purchase and installation, the buyer assumes the entire costs of any necessary servicing, repair, or replacement.

Note: This is not a simple bolt on. Some adjustments may be required to properly fit the hood. It is recommended that you oversize the four holes where the hinges join together. This will allow you to adjust your hood height and front to back spacing. Further adjusting of the fender alignment to hood can be accomplished by loosening the screws that hold the fender to the inner wheel well, and if necessary to place the shims or washers between the fender lip and inner fender well to adjust gap.