ACS Chevrolet Camaro TL1 ZL1 Replica Extractor Hood Insert 2010-2014

Add style to your 2010-2014 Chevrolet Camaro by add the ZL1 Replica Hood Inserts by ACS.

The TL1 Hood Insert self-install kit, the coolest way to upgrade your stock hood. That's right, modify your Aluminum Hood and save on re-paint and the hassles with replacement hoods. The ACS TL1 Hood Insert self install kit pays homage to the Zl1 while matching the lines of the existent stock hood of your Camaro.

Other than its lightness the original Camaro Hood does not offer any performance advantages, until now that is. Install the Tl1 Hood Insert to extract the engines hot air, and reduce body lift at high speed by relieving under hood pressure. Trim your hood following our guide and templates, rest assured every trimmed edge will be covered (Margin of error, +/- 1/8'' outer). Hood insert kit includes a water management system draining the water towards the front radiator support away from critical engine electronics. For extreme events like racing, you can easily remove the deflector for an optimum suction effect.

Insert is made in ACS's proprietary RTM process and is shipped in a primer finish ready for prep and paint. Unlike conventional fiberglass ACS's RTM process has been tested to withstand heat and distortion. Stock hood will need to be trimmed and 6 mounting holes will need to be drilled. Includes the Insert, rain water deflector, mounting hardware, octagonal grill mesh kit powder coated black and templates.

Reduce body lift and engine heat by upgrading your Camaro Hood while saving on repainting or heavy cost associated with replacement hoods.

Includes
1 - ACS TL1 Hood Insert
1 - ACS TL1 Water Deflector
1 - Front Passenger Side Hood Grill, Octagonal Mesh
1 - Rear Passenger Side Hood Grill, Octagonal Mesh
1 - Front Driver Side Hood Grill, Octagonal Mesh
1 - Rear Driver Side Hood Grill, Octagonal Mesh
6 - M6 Nut with Mounted Washer
3 - M6 U nut
3 - M6 Bolt
2 - Large Washers
4 - Standard Washers
2 - Cap Plugs
1 – Tl1 Template
1 - Adhesive Cartridge
4 – Tie Wraps
Instructions







Other than its lightness the original Camaro Hood does not offer any performance advantages, until now that is. Install the Tl1 Hood Insert to extract the engines hot air, and reduce body lift at high speed by relieving under hood pressure. Trim your hood following our guide and templates, rest assured every trimmed edge will be covered (Margin of error, +/- 1/8'' outer). Hood insert kit includes a water management system draining the water towards the front radiator support away from critical engine electronics. For extreme events like racing, you can easily remove the deflector for an optimum suction effect.

Insert is made in ACS's proprietary RTM process and is shipped in a primer finish ready for prep and paint. Unlike conventional fiberglass ACS's RTM process has been tested to withstand heat and distortion. Stock hood will need to be trimmed and 6 mounting holes will need to be drilled. Includes the Insert, rain water deflector, mounting hardware, octagonal grill mesh kit powder coated black and templates.

Reduce body lift and engine heat by upgrading your Camaro Hood while saving on repainting or heavy cost associated with replacement hoods.

PN 33-4-095