2016-2024 Nissan Titan XD SSK Style Functional Ram Air Hood

2016-2024 Titan Type-SSK Style Functional Ram Air Hood NT16AHSSKFHWXD


Hand Laid High Quality Fiberglass and Resin
Functional Ram Air Tunnel Build In, No Extra Charges!
Easy Installation, Utilized Factory Hinges and Latch
Gel Coat Finished On Both Top And Under Side For Easier Prep prior Painting
Aluminum Wire Mesh Grill Inserts Included Where Applicable


Replace your Nissan Titan OE hood and upgrade with a Ram Air heat extractor hood with fantastic styling. This hood is well fitted and takes little prep time in comparison to many other aftermarket hoods.


Functional ram air hood for Nissan Titan is perfect replacement for the ordinary factory hood. Also features two heat extractor vents to draw hot air from the engine bay. Hood utilized factory hinges and striker for easier installation, smooth gel coat finish on top and underside for easy prep and shorten work time for that perfect finish.


Installation Note
Please Dry Fit The Product Prior Performing Prep And Painting Work. This Hood Requires Hand-Finishing For Paint Prep and Fitment. This is NOT a Simple Bolt-On!





Important When Receiving Freight: upon receiving the product(s) please be sure to inspect the item(s) for "freight damage". If there are signs of freight damage you must refuse the item due to damage then contact us immediately. Make sure to open and inspect all content(s) before signing [this includes removing the wrapping bubbles and plastics to physically inspect the item(s)]. This process usually takes about 5-10 minutes. It is the customer's responsibility to inspect the item thoroughly. If a customer fails to fully open up the box(es) and inspect their merchandise for damage, and signs the freight carrier's paperwork indicating that all merchandise was inspected (which is what is stated on all freight carriers paperwork), inspects their merchandise after the freight carrier leaves and then finds damage, or what is called "concealed damage", neither the freight carrier, nor BMC Extreme Customs will be responsible to replace or pay for repairs to the product.

CargoEdge Insurance Coverage
Due to the size of the hood, they are vulnerable to getting damaged. It’s a common mistake to confuse freight insurance with the liability insurance provided by carriers and freight forwarders. They are not the same at all. Typical carrier or forwarder liability is limited, in some cases to no more than $5.00 per lb of stolen, lost, or damaged cargo, and coverage contains many exclusions. For a typical hood which weighs less than 50lbs, that's only $250 plus freight. CargoEdge Insurance is powered and backed by UPS Capital and adds a piece of mind should your order arrive damaged or stolen.

*DISCLAIMER: All aftermarket hoods sold are either for show or off-road use only. Professional installation & Hood pins are required! The buyer assumes the entire risk as to the quality of the aftermarket parts. In the event such parts prove defective following the purchase and installation, the buyer assumes the entire costs of any necessary servicing, repair, or replacement.

Note: This is not a simple bolt on. We want all consumers to know that there will always be sanding, shaving, cutting, and/or filling prior to installing aftermarket parts. Also, the black primer finish must be sanded and other prep work will be required prior to painting. Some adjustments may be required to properly fit the hood. It is recommended that you oversize the four holes where the hinges join together. This will allow you to adjust your hood height and front to back spacing. Further adjusting of the fender alignment to hood can be accomplished by loosening the screws that hold the fender to the inner wheel well, and if necessary to place the shims or washers between the fender lip and inner fender well to adjust gap.