Upgrade the performance and design of your 2015-2018 Type-SA carbon hood for Ford Focus by Anderson Composite. Made to fit your Focus ST 2015-2017 or Focus RS 2016-2017.
Features
*Mesh screen is removable & paintable
*Mounts with OE hardware
*Requires hood pins for safety reasons
*Strongly recommend the use of a heat shield
*Anderson Composites does not suggest re-installing gas shocks/dampers/struts
Type-SA carbon hood for 2016-up Ford Focus
WET Carbon Fiber - This product is manufactured Wet using 3K, 2~2 Twill Weave Carbon Fiber, and Anderson Composites proprietary vacuum infusion process. The industry calls this process Wet because the resin is introduced into the mold as a liquid; this process produces a high gloss, wet-look shiny finish. It is highly recommended to use an automotive clear with UV inhibitors to prolong the life and finish of the product.
Fiberglass skeleton bonded to the underside of carbon fiber hood for strength and support
Replaces OE Focus RS hood - will fit 2025-2016 Focus ST
Mounts with OE hardware
Requires hood pins for safety reasons
Do not install gas hood shocks, dampers, or struts
Strongly recommend the use of a heat shield
Warranty and Disclaimer
Items sold by Anderson Composites may not be legal for street use in all states. It is the buyerfs responsibility to comply with applicable state laws. Buyer understands that due to strict U.S. Federal and State safety crash guidelines, Anderson Composites is not responsible or liable for any damages or possible injuries incurred upon possible accidents due to driver error, incorrect installations, bad judgment, or act of nature/God, Allah, Jehovah, etc. All products are intended for off-highway uses only, and should be used for their intended purposes only. Anderson Composites does not take responsibility over buyer installation, modification, and unusual stress of the products. The buyer assumes all responsibilities for determining the suitability of the products. Anderson Composites is not responsible for any damages incurred either directly or indirectly on the vehicles or operators/passengers within the vehicles.
The following situations are fully covered under the Anderson Composites Fitment Guarantee:
Hood does not clear a stock engine
Gap between the hood and the fenders are more than 1/2 wide on each side
Hood levels more than 1/4 higher or lower than the fenders
Latch is 1/16 too long or too short than the stock latch, causing the hood not to latch
Please note that Anderson Composites does not suggest re-installing gas hood shocks/dampers/struts.
Anderson Composites does not guarantee fitment on cars that have been involved in accidents and/or had body damages.
Anderson Composites strongly recommends the use of heat shields. Damages to the hood that results from the absence of heat shields will not be covered under warranty.