1999-2015 Mazda Miata MX-5 Rally Stripes Graphic Kit
| |||
Set your 1999-2015 Mazda MX-5 Miata Hardtop and Convertible apart from the rest with this unique Rally Stripe hood, roof and rear lid graphic kit. This easy-to-install kit is packaged as a set of eight (8) to twelve (12) pieces. They're PRECUT and ready to install in a wide variety of colors - NO TRIMMING required! This stripe package is not just a set of 9" (22.86cm) straight strips in a box. Our graphic kit consists of prefitted and contoured pieces as shown in the illustration. Kit is specifically made for the '99-Current Mazda MX-5 Miata factory hood, roof and rear lid areas and will not fit any other vehicle. Rally stripes are set for 2" (50.80mm) center spacing at time of installation. Why the unique design for the hood area? Other than the fact that it looks great, we have found that installation of vinyl graphics within indentations as found in the '06-Current MX-5 Miata's factory hood do not hold up well due to lifting and water retention. Thus, in these situations we utilize creative solutions to enhance the vehicle while at the same time provide a graphic kit that will last for years to come. The design is merely for aesthetics on '99-'05 Miatas and '06-Current MX-5.  NOTE: Graphics are made to order to ensure freshness of vinyl for easier installation. Please allow 4-7 business days for production. Kits are typically shipped with USPS Priority Mail. *INSTALLATION: Add an application squeegee and application fluid for easier installation at home. WRAP FILM*: We recommend to NOT use application fluid, but rather prep solution, when working with Wrap Film. Most of our vinyl is High Performance Premium Cast Vinyl and can be installed wet while Wrap Film should only be installed dry (no application fluid). RETURN POLICY FOR GRAPHICS: 30 Days Return Policy. Please note that due to the large number of color options and configurations, graphics are considered custom work and any graphics returned will have a 35% restock fee. Graphics kits with custom wording/text cannot be returned or refunded after it has been cut. MORE NOTES: We use high-performance premium cast vinyl unless otherwise noted. We cut our vinyl to be approximately 1/16"-1/8" from edge in order to prevent peeling/pull back and allows for easier installation by not requiring installer to remove car parts. Although our vinyl may resemble the OEM designs, it may not be consistent with the OEM lengths. Many OEM vinyl kits are made so that they go around edges and require removal of your vehicle parts such as grilles and bumpers. Kits do NOT come pre-spaced in packaging as to ensure customers remove and align each piece individually for correct placement and installation. | |||
Accessories
