1984-1996 Chevrolet Corvette C4 Rally Stripe Graphic Kit 1
| |||
Make your Corvette C4 Coupe or Convertible stand out with this Bumper, Hood, Roof and Rear Deck Lid Rally Stripe Graphics kit. Fits 1984 1985 1986 1987 1988 1989 1990 1991 1992 1993 1994 1995 1996 Chevrolet Corvette C4 (Coupe or Convertible). Coupe (shown) kit comes with fifteen (15) pieces while the convertible is provided with eleven (11) pieces. They're PRECUT and ready to install in a wide variety of colors - there is NO TRIMMING required! This stripe package is not just a set of 10" strips in a box. Our graphic kit consists of prefitted and contoured pieces as shown in the illustration and specifically fits any '84-'96 Corvette C4 with factory hood, roof and rear deck lid areas. It will not fit any other vehicle. Stripe width is approximately 11" (27.94cm) and set for a center spacing of 3" (7.62cm) while a .20" (.51 cm) pinstripe borders the outside edge as shown. Optional Spoiler Kit consists of two (2) precut 10.76"x 14" (27.33cm x 35.56cm) pieces that require slight trimming (to length) once installed. Click on thumbnail to view the pieces provided.  NOTE: Graphics are made to order to ensure freshness of vinyl for easier installation. Please allow 4-7 business days for production. Kits are typically shipped with USPS Priority Mail. *INSTALLATION: Add an application squeegee and application fluid for easier installation at home. WRAP FILM*: We recommend to NOT use application fluid, but rather prep solution, when working with Wrap Film. Most of our vinyl is High Performance Premium Cast Vinyl and can be installed wet while Wrap Film should only be installed dry (no application fluid). RETURN POLICY FOR GRAPHICS: 30 Days Return Policy. Please note that due to the large number of color options and configurations, graphics are considered custom work and any graphics returned will have a 35% restock fee. Graphics kits with custom wording/text cannot be returned or refunded after it has been cut. MORE NOTES: We use high performance premium cast vinyl unless otherwise noted. We cut our vinyl to be approximately 1/16"-1/8" from edge in order to prevent peeling/pull back and allows for easier installation by not requiring installer to remove car parts. Although our vinyl may resemble the OEM designs, it may not be consistent with the OEM lengths. Many OEM vinyl kits are made so that they go around edges and require removal of your vehicle parts such as grilles and bumpers. Kits do NOT come pre-spaced in packaging as to ensure customers remove and align each piece individually for correct placement and installation. | |||
Accessories
