2011-2018 Jeep Grand Cherokee/Dodge Durango 5.7L K&N Performance Air Intake

Product Info: Manufacturer: K&N Engineering Pricing Group: K&N

K&N 11 Jeep Grand Cherokee 5.7L V8 & 11 Dodge Durango 5.7L V8 High Flow Performance Intake Kit
Product Name: KN 77 Metal Intake
Box 1 Dims (LxWxH-W): 22.25 x 14.25 x 12.5 - 11.75
Part Number: kn77-1563KP Description: Performance Air Intake System
Estimated Horse Power Gain: 15.01 HP @ 4500 RPM
**Guaranteed to increase horsepower
**Designed to improve throttle response and engine sound
**Free-flowing aluminum tube
**Replaces entire factory air intake system
**Lasts up to 100,000 miles before service is required (depending on driving conditions)
**Easy to install, usually in 90 minutes or less
**Washable and reusable lifetime air filter
**K&N Million Mile Limited Warranty


The K&N 77-1563KP high-flow performance air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Jeep Wrangler and Dodge Durango models. The restrictive factory air filter and air intake housing on your vehicle are replaced by this K&N air intake system which is designed to dramatically reduce air flow restriction as it smoothes and straightens air flow. The improved air flow allows your engine to inhale a larger amount of air than it would from the stock air intake. More air means more usable power and acceleration throughout your engine’s RPM range. The 77-1563KP air intake comes with a chrome topped K&N high-flow air filter and a heat shield that installs into the previous air box space. Air is directed through the intake tube into the engine’s throttle body for a guaranteed power gain. The intake tube has an attractive chrome-like finish that's made to last and it accommodates the factory inlet air temperature sensor and crank case vent hose. The oversized cone shaped air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points. The tools needed are a screwdriver, pliers, ratchet set and some wrenches.